• Thread: 1 (F) NPT
• Maximum Working Pressure: 230 PSI
• Working Temperature: 1 to 50 °C
• Fluid Temperature: 1 to 100 °C
• Voltage: 115V / 50/60Hz
• Power Consumption: 7W during cycle rotation
• Classification: IP54 (NEMA 13)
• Opening/Closing duration: 30 sec
• Valve opens slowly to avoid water hammer in network
• Manual valve opening and closing possible, in case of a power failure
• Microprocessor controlled (multi cycle 7 day program)
• Each individual day can be programmed according to specific working day shift requirements
• Integral lithium battery protects program
• Reset Function
• Maintenance free
• Easy to obtain air in case of overtime work
• Large LCD display showing program cycle and current time
• Compact design - easy to install-easy to program
• No unnecessary start up of compressors during periods when compressed air is not required
• Allows the possibility to shut off sections of an air system where compressed air isn’t continuously needed
INSTALLATION TIP
90% of air leaks are generated at the production area. In order to minimize the negative impact of these leaks the AIR-SAVER ball valve, installed on the air outlet of the air tank, it will:
- Automatically OPEN just prior to the work shift
- Automatically CLOSE just after the work shift is over
The content of compressed air within the air tank will be saved rather than lost through pipe work leakages
• Thread: 1 (F) NPT
• Maximum Working Pressure: 230 PSI
• Working Temperature: 1 to 50 °C
• Fluid Temperature: 1 to 100 °C
• Voltage: 115V / 50/60Hz
• Power Consumption: 7W during cycle rotation
• Classification: IP54 (NEMA 13)
• Opening/Closing duration: 30 sec
• Valve opens slowly to avoid water hammer in network
• Manual valve opening and closing possible, in case of a power failure
• Microprocessor controlled (multi cycle 7 day program)
• Each individual day can be programmed according to specific working day shift requirements
• Integral lithium battery protects program
• Reset Function
• Maintenance free
• Easy to obtain air in case of overtime work
• Large LCD display showing program cycle and current time
• Compact design - easy to install-easy to program
• No unnecessary start up of compressors during periods when compressed air is not required
• Allows the possibility to shut off sections of an air system where compressed air isn’t continuously needed
INSTALLATION TIP
90% of air leaks are generated at the production area. In order to minimize the negative impact of these leaks the AIR-SAVER ball valve, installed on the air outlet of the air tank, it will:
- Automatically OPEN just prior to the work shift
- Automatically CLOSE just after the work shift is over
The content of compressed air within the air tank will be saved rather than lost through pipe work leakages
